Welcome to GTrydaz.com! Be a part of Australia's largest Subaru Forester community, Register for FREE.              | 
GTrydaz Forum
Welcome, Guest
Please Login or Register.    Lost Password?
GTrydaz Forum Forester Specific Topics 03-07 NA
Re:Options for custom NA air intake (1 viewing) (1) Guest
Go to bottom Post Reply Favoured: 0
TOPIC: Re:Options for custom NA air intake
Logged Logged   #576447
Surok


Corner Artist
ProRyda
Posts: 1891
surok86@yahoo.co.jp Location: Sydney 99 Forester GT / 1997 MR2 /
User Offline Click here to send a Private Message to this user Click here to see the profile of this user
Re:Options for custom NA air intake 29/04/2008 10:26pm  
why dont you just rotate the inlet manifold.
lots of wrxs have that done. then you can have that LS7 air filter
 
  The administrator has disabled public write access.
Logged Logged   #576449
apg39


Now accepting donations for the Andrewsmodfund...
Registered
Posts: 719
User Offline Click here to send a Private Message to this user Click here to see the profile of this user
Re:Options for custom NA air intake 29/04/2008 10:31pm  
Surok:

why dont you just rotate the inlet manifold.
lots of wrxs have that done. then you can have that LS7 air filter


Ive read into that but i dont think it was possible for my model, Ill have another look though. Still, the TB would be too far forward & that LS7 intake would sit too low methinks, the Liberty scoop feeds about 10cm past the alternator, almost on top of the centre of the manifold.
  The administrator has disabled public write access.
Logged Logged   #576452
Surok


Corner Artist
ProRyda
Posts: 1891
surok86@yahoo.co.jp Location: Sydney 99 Forester GT / 1997 MR2 /
User Offline Click here to send a Private Message to this user Click here to see the profile of this user
Re:Options for custom NA air intake 29/04/2008 10:54pm  
could you not just cut a bit out of the bopnnet just above where the grille goes
like make the grille taller
 
  The administrator has disabled public write access.
Logged Logged   #602948
Suparoo


Registered
Posts: 8
User Offline Click here to send a Private Message to this user Click here to see the profile of this user
Re:Options for custom NA air intake 06/10/2008 07:14pm  
That Y splitter looks like an after market intake for a late model Holden V8
  The administrator has disabled public write access.
Logged Logged   #602958
buddo_007


you can have all the power in the world, untill the first corner
ProRyda
Posts: 1410
buddo_007@hotmail.com Location: wavell heights, QLD 2007 MY08 Foz XT
User Online Now Click here to send a Private Message to this user Click here to see the profile of this user
Re:Options for custom NA air intake 06/10/2008 08:23pm  
that Y splitter would be good as it sits a little foward then the scoop thats the rain problem sorted out and you still have the cold air there

but if you where going to do that i'd take the bottom engine cover off so the air has somewhere to escape

Damo
 
IT TAKES MANY NAILS TO BUILD A CRIB, BUT ONLY A SCREW TO FILL IT
  The administrator has disabled public write access.
Go to top Post Reply
Powered by FireBoardget the latest posts directly to your desktop